- a -

• assert_param : stm32f1xx_hal_conf.h
• ATOU_ERROR : app_shell_if.c
• ATOU_MAX_CHAR : app_shell_if.c

- b -

• BYTE_MAX : app_shell_if.c

- c -

• CONVERT_10ADDR : i2c.c
• CONVERT_7ADDR : i2c.c

- d -

• DEFAULT_ADC_NUM_OF_SAMPLES : PHiLIP_defaults.h
• DEFAULT_DAC_LEVEL : PHiLIP_defaults.h
• DEFAULT_I2C_SLAVE_ADDR_1 : PHiLIP_defaults.h
• DEFAULT_I2C_SLAVE_ADDR_2 : PHiLIP_defaults.h
• DEFAULT_PWM_H_TICKS : PHiLIP_defaults.h
• DEFAULT_PWM_L_TICKS : PHiLIP_defaults.h
• DEFAULT_SYS_DEVICE_NUM : PHiLIP_defaults.h
• DEFAULT_TMR_MIN_TICK : PHiLIP_defaults.h
• DIS_INT : app_common.h
• DP83848_PHY_ADDRESS : stm32f1xx_hal_conf.h

- e -

• EN_INT : app_common.h
• ETH_RX_BUF_SIZE : stm32f1xx_hal_conf.h
• ETH_RXBUFNB : stm32f1xx_hal_conf.h
• ETH_TX_BUF_SIZE : stm32f1xx_hal_conf.h
• ETH_TXBUFNB : stm32f1xx_hal_conf.h
• EXECUTE_CMD : app_shell_if.c

- f -

• FLASH_TIME_MS : led_flash.c

- h -

• HAL_ADC_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HAL_CORTEX_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HAL_DMA_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HAL_FLASH_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HAL_GPIO_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HAL_I2C_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HAL_IWDG_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HAL_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HAL_PWR_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HAL_RCC_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HAL_RTC_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HAL_SPI_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HAL_TIM_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HAL_UART_MODULE_ENABLED : stm32f1xx_hal_conf.h
• HELP_CMD : app_shell_if.c
• HSE_STARTUP_TIMEOUT : stm32f1xx_hal_conf.h
• HSE_VALUE : stm32f1xx_hal_conf.h , system_stm32f1xx.c
• HSI_VALUE : stm32f1xx_hal_conf.h , system_stm32f1xx.c

- i -

• IF_VERSION_MAJOR : PHiLIP_map.h
• IF_VERSION_MINOR : PHiLIP_map.h
• IF_VERSION_PATCH : PHiLIP_map.h
• IS_COMMAND : app_shell_if.c
• IS_NUM : app_shell_if.c
• IS_RX_WAITING : uart.c
• IS_STATE_WRITING : i2c.c

- l -

• LSE_STARTUP_TIMEOUT : stm32f1xx_hal_conf.h
• LSE_VALUE : stm32f1xx_hal_conf.h
• LSI_VALUE : stm32f1xx_hal_conf.h

- m -

• MAC_ADDR0 : stm32f1xx_hal_conf.h
• MAC_ADDR1 : stm32f1xx_hal_conf.h
• MAC_ADDR2 : stm32f1xx_hal_conf.h
• MAC_ADDR3 : stm32f1xx_hal_conf.h
• MAC_ADDR4 : stm32f1xx_hal_conf.h
• MAC_ADDR5 : stm32f1xx_hal_conf.h
• MAJOR_FLASHES : led_flash.c
• MAP_T_NUM_OF_RECORDS : PHiLIP_map.h
• MEMORY_MAP_CMD : app_shell_if.c
• MINOR_FLASHES : led_flash.c
• MM_SIZE_CMD : app_shell_if.c

- n -

• NUM_OF_TRACES : trace.c

- p -

• PATCH_FLASHES : led_flash.c
• PHY_AUTONEGO_COMPLETE : stm32f1xx_hal_conf.h
• PHY_AUTONEGOTIATION : stm32f1xx_hal_conf.h
• PHY_BCR : stm32f1xx_hal_conf.h
• PHY_BSR : stm32f1xx_hal_conf.h
• PHY_CONFIG_DELAY : stm32f1xx_hal_conf.h
• PHY_DUPLEX_STATUS : stm32f1xx_hal_conf.h
• PHY_FULLDUPLEX_100M : stm32f1xx_hal_conf.h
• PHY_FULLDUPLEX_10M : stm32f1xx_hal_conf.h
• PHY_HALFDUPLEX_100M : stm32f1xx_hal_conf.h
• PHY_HALFDUPLEX_10M : stm32f1xx_hal_conf.h
• PHY_ISOLATE : stm32f1xx_hal_conf.h
• PHY_JABBER_DETECTION : stm32f1xx_hal_conf.h
• PHY_LINKED_STATUS : stm32f1xx_hal_conf.h
• PHY_LOOPBACK : stm32f1xx_hal_conf.h
• PHY_POWERDOWN : stm32f1xx_hal_conf.h
• PHY_READ_TO : stm32f1xx_hal_conf.h
• PHY_RESET : stm32f1xx_hal_conf.h
• PHY_RESET_DELAY : stm32f1xx_hal_conf.h
• PHY_RESTART_AUTONEGOTIATION : stm32f1xx_hal_conf.h
• PHY_SPEED_STATUS : stm32f1xx_hal_conf.h
• PHY_SR : stm32f1xx_hal_conf.h
• PHY_WRITE_TO : stm32f1xx_hal_conf.h
• PREFETCH_ENABLE : stm32f1xx_hal_conf.h

- r -

• READ_KEY_CMD : app_shell_if.c
• READ_REG_CMD : app_shell_if.c
• RESET_CMD : app_shell_if.c
• RX_END_CHAR : app_shell_if.h

- s -

• SOFT_RESET : app_common.h
• SPI_ADDR_MASK : spi.c
• SPI_NO_DATA_BYTE : spi.h
• START_WAIT_FLASHES : led_flash.c

- t -

• T_SIZE : map_if.c
• TICK_BIT_OFFSET : app_common.h
• TICK_INT_PRIORITY : stm32f1xx_hal_conf.h
• TX_END_STR : app_shell_if.h

- u -

• UART_DUT_BUF_SIZE : uart.h
• UART_IF_BUF_SIZE : uart.h
• USE_RTOS : stm32f1xx_hal_conf.h

- v -

• VDD_VALUE : stm32f1xx_hal_conf.h
• VECT_TAB_OFFSET : system_stm32f1xx.c
• VERSION_CMD : app_shell_if.c
• VERSION_CMD2 : app_shell_if.c
• VERSION_CMD3 : app_shell_if.c
• VERSION_CMD4 : app_shell_if.c

- w -

• WAIT_FLASHES : led_flash.c
• WRITE_KEY_CMD : app_shell_if.c
• WRITE_REG_CMD : app_shell_if.c